Honeywell HZ-341 Manuel d'utilisateur télécharger pdf (Page 4)

REMOTE CONTROL OPERATION

(CONTINUED)

NOTE: If operated at the Low setting, the heater will not provide as much heat output as in the High

setting, however, the Low setting will not require as much electrical current to operate. To avoid

overloading a circuit, do not plug the heater into a circuit that already has other appliances working.

STEP 2: SET TEMPERATURE

• Press the Mode button until the Temperature Icon ( ) blinks.

The current room temperature will appear (Fig. 9).

• Use the Up and Down arrow buttons ( ) to set the Desired

Temperature (Fig. 9).

• The Temperature Icon ( ) will stop blinking and the current room

temperature will reappear after the Desired Temperature is set.

• The heater will turn off shortly after the Desired Temperature is

reached and the Temperature Display will blink.

• The heater will turn back on when the room temperature drops

below the Desired Temperature. The Temperature Display will

then stop blinking and will display the current room temperature.

STEP 3: SET TIMER

NOTE: This function should only be set if you desire that the heater be

automatically shut off after a certain period of time (1 to 10 hours

from the time the function is set). Always set the Desired

Temperature prior to setting the Timer (see Step 2) so that the heater

will shut off at the Desired Temperature setting and not run

continuously.

• Press the Mode button until the Timer Icon ( ) blinks. The Hour

Display will appear. The Auto Off icon will also appear (Fig. 9).

• Use the Up and Down arrow buttons ( ) to set the heater

operation time between 1 and 10 hours (Fig. 9). Once the timer

function is set the hour set will remain displayed until the time set runs out.

• The heater will automatically turn off when time runs out.

NOTE: If the Desired Temperature was set prior to setting the Timer function, the heater will cycle on and

off as per the selected Desired Temperature setting. To return to Continuous Run Mode (Fig. 1), press the

Mode button a third time.

STEP 4: OSCILLATION

• The Oscillation feature functions in all Power and Temp/Timer settings.

• Press the Oscillation button to toggle this feature on and off (Fig. 10).

Fig. 9

Fig. 10

Down

Mode

Oscillation

HZ-339_341_OM_Rev2.qxd 6/22/05 5:15 PM Page 4

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Honeywell HZ-341 Manuel d'utilisateur Page 4