Honeywell T8511G Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Panneau de contrôle Honeywell T8511G. Honeywell T8511G User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
X-XX UL
INSTALLATION INSTRUCTIONS
®U.S. Registered Trademark • • All Rights Reserved
Microelectronic
Heat Pump Thermostats
T8511G
APPLICATION
The T8511G Microelectronic Heat Pump Thermostat provides electronic control of 24 Vac, two-stage heating and one-
stage cooling heat pump systems. Refer to Table 1 for a general description of the thermostat. All T8511 Thermostats
require a common wire to supply power.
Table 1. T8511 Thermostat Desription.
MERCURY NOTICE
If this control is replacing a control that contains
mercury in a sealed tube, do
not
place your old
control in the trash.
Contact your local waste management authority for
instructions regarding recycling and the proper
disposal of the old thermostat.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow
the instructions can damage the product or cause a
hazardous condition.
2. Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.
3. Installer must be a trained, experienced service
technician.
4. After completing installation, use these instructions
to check out the product operation.
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
Location
Install the thermostat about 5 ft (1.5m) above the floor in
an area with good air circulation at average temperature.
See Fig. 1.
Do not install the thermostat where it can be affected by:
drafts, or dead spots behind doors and in corners.
hot or cold air from ducts.
radiant heat from sun or appliances.
concealed pipes and chimneys.
unheated (uncooled) areas such as an outside wall
behind the thermostat.
Wallplate Installation
Mount tthermostat horizontally on the wall or on a 2 in. x 4
in. wiring box.
1. Position and level the wallplate (for appearance
only). The thermostat functions properly even when
not level.
T8511 Changeover System Selection
Fan
Selection Comments
G Automatic Em. Heat-Heat-Off-Auto-Cool On-Auto Use keyboard to make system and
fan selections.
69-0961-4
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - Heat Pump Thermostats

X-XX ULINSTALLATION INSTRUCTIONS®U.S. Registered Trademark • • All Rights ReservedMicroelectronicHeat Pump ThermostatsT8511GAPPLICATIONT

Page 2 - IMPORTANT

69-0961—410MICROELECTRONIC HEAT PUMP THERMOSTATTROUBLESHOOTING GUIDE (Continued)aAvailable on select models.Symptom Possible Cause ActionHeating will

Page 3 - Mounting Thermostat

69-0961—411MICROELECTRONIC HEAT PUMP THERMOSTAT

Page 4 - SETTINGS

Honeywell Limited-Honeywell Limitée35 Dynamic DriveScarorough, OntarioM1V 4Z969-0961—4 G.H. Rev. 05-04Automation and Control SolutionsHoneywell In

Page 5 - INSTALLER SETUP

69-0961—42MICROELECTRONIC HEAT PUMP THERMOSTATFig. 1. Typical location of thermostat.5 FEET[1.5 METERS]YESNONONOM10106Fig. 2. Mounting the wallplate.2

Page 6

69-0961—43MICROELECTRONIC HEAT PUMP THERMOSTATFig. 3. Typical hookup in heat pump application.Fig. 4. Typical hookup in heat pump systemwith emergency

Page 7 - INSTALLER SYSTEM-TEST

69-0961—44MICROELECTRONIC HEAT PUMP THERMOSTATFig. 10. T8511G (automatic changeover) systemand fan key locations.NOTE: Always press the system and fan

Page 8 - Thermostat Information

69-0961—45MICROELECTRONIC HEAT PUMP THERMOSTATINSTALLER SETUPNOTE: For most applications, the thermostat factorysettings do not need changing. Review

Page 9 - TROUBLESHOOTING GUIDE

69-0961—46MICROELECTRONIC HEAT PUMP THERMOSTATTable 2. Thermostat Installer Setup Options (Continued).Installer Setup Number(Press i keyFactory S

Page 10

69-0961—47MICROELECTRONIC HEAT PUMP THERMOSTATEm HeatOffCool Auto OnlyHeat CoolOnAutoSystem FanRoomOutdoorEm Ht Temporary SettingWait%HumidAux HtRemot

Page 11 - 69-0961—4

69-0961—48MICROELECTRONIC HEAT PUMP THERMOSTATTable 4. Installer System-Test Options (Continued).M6791M4864M4865M4866Thermostat Information1. Press th

Page 12 - 69-0961—4 G.H. Rev. 05-04

69-0961—49MICROELECTRONIC HEAT PUMP THERMOSTATM48675. Press the increase ▲ key again to display theEEPROM identification code (Example: 222 =EEPROM ID

Commentaires sur ces manuels

Pas de commentaire