Honeywell Genesis 7580 Guide de l'utilisateur télécharger pdf (Page 41)

Configuration for EAS Applications

EAS support is disabled by default in the MS7580-124-EAS series. To enable

EAS support the imager must be configured for a system type and signal mode.

Follow the configuration sequence below to configure the imager for EAS

functionality.

1. Scan the system type bar code below to enable EAS system support.

Enable Checkpoint System EAS Support

³ 3 3 7 2 2 0

2. Scan either the Enable Continuous Mode bar code

Regular Mode

In regular EAS mode, the imager will signal the EAS system to

activate immediately after the area imager successfully transmits a

bar code. The imager will also signal the EAS system to deactivate

after the configured EAS timeout expires.

the Enable Regular

Mode bar code.

Note: If regular mode is enabled an EAS timeout length will need to

be configured (see page 38).

Enable Regular Mode

³ 1 4 6 1 0 5

Continuous Mode

In continuous mode, the imager will signal the EAS system to activate

when it first powers on. The area imager will never deactivate the

EAS system while in continuous mode. The EAS timeout setting has

no effect in continuous mode.

Enable Continuous Mode

³ 1 4 6 1 1 5

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Pas de commentaire

Honeywell Genesis 7580 Guide de l'utilisateur Page 41