Honeywell MAGICSTAT CT3300 Manuel d'utilisateur télécharger pdf (Page 3)

69-0654-5 INSTALLATION

Step 1. Prepare for installation

a. Carefully unpack your new thermostat. Save your receipt and make sure you have the following parts:

b. Gather the needed tools and supplies listed below.

c. Make sure that your heating and cooling systems are working properly. If there is a problem with either system, call a

heating/air conditioning contractor—the problem may persist after you install the new thermostat.

Required tools and supplies Optional tools

• Two AA alkaline batteries. Honeywell recommends

Energizer® batteries.

• Screwdriver

• Hand or power drill with 3/16-inch or 7/32-inch drill bit

•Pencil

• Wire cutter/stripper or sharp knife

•Level

• Electrical tape

IMPORTANT:

To avoid damaging the compressor in the air conditioner, do not operate the cooling system when the

temperature outdoors is below 50°F (10°C).

• Thermostat and mounting plate

• Labels

• Screws and anchors

• Installation and Programming Instructions

1 2 3 4 5 6 7 8 ... 23 24

Pas de commentaire

Honeywell MAGICSTAT CT3300 Manuel d'utilisateur Page 3