Honeywell 2020 Manuel d'utilisateur télécharger pdf (Page 182)

B - 2

Maximum Link Attempts

The Maximum Link Attempts setting controls the number of times the image

scanner tries to form a connection with a base unit or PC. During the

connection setup process, the image scanner transmits in order to search for

and connect to a base unit. In order to prevent continuous transmissions that

could interfere with other users of the ISM band, the number of attempts to

connect is limited by this setting. After the maximum number of attempts is

reached, the image scanner will not attempt to reconnect to the base unit.

Pressing the trigger or placing the image scanner in the cradle resets the

attempt count and the image scanner will again try to link to the base unit.

When set to zero, the image scanner will try to link until the Power Time-Out

Timer setting (see page 3-4) expires.

Scan the Maximum Link Attempts barcode, then scan the number of attempts

for the setting (from 0-100) from the inside back cover. Scan Save to save the

setting.

Default = 0.

Image scanner

power down due to

Power Time-Out

Timer setting (see

page 3-4)

Trigger must be pulled or the image scanner must be

placed in the base unit to re-link.

(Note: image scanner re-links on power up, but

powers on due to one of the above actions.)

Image scanner

reset due to

firmware upgrade

Re-link occurs automatically.

Image scanner

reset due to battery

change

Re-link occurs automatically.

Image scanner

placed in different

base unit

Re-link to new base occurs automatically.

Event Auto Reconnect On Auto Reconnect Off

Maximum Link Attempts

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 188

Pas de commentaire

Honeywell 2020 Manuel d'utilisateur Page 182