Honeywell 2020 Manuel d'utilisateur télécharger pdf (Page 84)

5 - 2

Step 4. Code I.D.

In the Appendix A, find the symbology to which you want to apply the

data format. Locate the Hex value for that symbology and scan the 2

digit hex value from the Programming Chart inside the back cover of

this manual.

Step 5. Length

Specify what length (up to 9999 characters) of data will be acceptable

for this symbology. Scan the four digit data length from the Program-

ming Chart inside the back cover of this manual. (Note: 50 characters

is entered as 0050. 9999 is a universal number, indicating all lengths.)

Step 6. Editor Commands

Refer to the Format Editor Commands Chart (page 5-2). Scan the

symbols that represent the command you want to enter. 94 alphanu-

meric characters may be entered for each symbology data format.

Step 7. Scan Save from the Programming Chart inside the back cover of this

manual to save your entries.

Other Programming Selections

• Clear One Data Format

This deletes one data format for one symbology. If you are clearing the

primary format, scan 0 from the Programming Chart inside the back cover of

this manual. If you are clearing an alternate format, scan 1, 2, or 3, depending

on the alternate format you are clearing. Scan the Terminal Type (refer to the

Supported Terminals Chart on page 2-2), Code I.D. (refer to the Symbology

Chart on page A-1), and the barcode data length for the specific data format

that you want to delete. All other formats remain unaffected.

• Save from the Programming Chart inside the back cover of this manual

This exits, saving any Data Format changes.

• Discard from the Programming Chart inside the back cover of this manual

This exits without saving any Data Format changes.

Data Format Editor Commands

Send Commands

F1 Send all characters followed by “xx” key or function code, starting from cur-

rent cursor position.

Syntax = F1xx

(xx stands for the hex value for an

ASCII code, see ASCII Conversion Chart (Code Page 1252) on page A-2.)

F2 Send “nn” characters followed by “xx” key or function code, starting from

current cursor position.

Syntax = F2nnxx

(nn stands for the numeric value

(00-99) for the number of characters and xx stands for the hex value for an

ASCII code. See ASCII Conversion Chart (Code Page 1252) on page A-2.)

F3 Send up to but not including “ss” character (Search and Send) starting from

current cursor position, leaving cursor pointing to “ss” character followed by

“xx” key or function code.

Syntax = F3ssxx

(ss and xx both stand for the

hex values for ASCII codes, see ASCII Conversion Chart (Code Page

1252) on page A-2.)

F4 Send “xx” character “nn” times (Insert) leaving cursor in current cursor posi-

tion.

Syntax = F4xxnn

(xx stands for the hex value for an ASCII code, see

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 187 188

Honeywell 2020 Manuel d'utilisateur Page 84

Commentaires sur ces manuels