Honeywell 2020 Manuel d'utilisateur télécharger pdf (Page 66)

3 - 4

Read Time-Out (Serial Trigger Mode)

Use this selection to set a time-out (in milliseconds) of the image scanner’s

trigger when using serial commands to trigger the image scanner. Once the

image scanner has timed out, you can activate the image scanner either by

pressing the trigger or using a serial trigger command. After scanning the Read

Time-Out barcode, set the time-out duration (from 0-300,000 milliseconds) by

scanning digits on the Programming Chart inside the back cover, then scanning

Save.

Default = 30,000 ms.

Image Scanner Power Time-Out Timer

Note: The Image Scanner Power Time-out Timer option only applies to Manual/

Serial Trigger.

When there is no activity within a specified time period, the image scanner enters

low power mode. Scan the appropriate Image Scanner Power Time-Out

barcode to change the time-out duration (in seconds).

Note: Scanning zero (0) is the equivalent of setting no time-out.

Read Time-Out

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 187 188

Pas de commentaire

Honeywell 2020 Manuel d'utilisateur Page 66