Honeywell 2020 Manuel d'utilisateur télécharger pdf (Page 135)

9 - 1

Visual Xpress

Visual Xpress Introduction

Visual Xpress provides a wide range of PC-based programming functions that

can be performed on an imager connected to your PC's COM port. Visual

Xpress allows you to download upgrades to the imager's firmware, change pro-

grammed parameters, and create and print programming barcodes. Using

Visual Xpress, you can even save/open the programming parameters for an

imager. This saved file can be e-mailed or, if required, you can create a single

barcode that contains all the customized programming parameters and mail or

fax that barcode to any location. Users in other locations can scan the barcode

to load in the customized programming.

To communicate with an imager, Visual Xpress requires that the PC have at

least one available serial communication port, or a serial port emulation using a

physical USB port. If you are using the serial port and RS-232 cable, an exter-

nal power supply is required. When using a USB serial port emulation, only a

USB cable is required.

Visual Xpress Operations

The Visual Xpress software performs the following operations:

Scan Data

Scan Data allows you to scan barcodes and display the barcode data in a win-

dow. Scan Data lets you send serial commands to the imager and receive

imager response that can be seen in the Scan Data window. The data dis-

played in the Scan Data window can either be saved in a file or printed.

Configure

Configure displays the programming and configuration data of the imager. The

imager's programming and configuration data is grouped into different catego-

ries. Each category is displayed as a tree item under the "Configure" tree node

in the application explorer. When one of these tree nodes is clicked, the right-

hand side is loaded with the parameters' form belonging to that particular cate-

gory. The "Configure" tree option has all the programming and configuration

parameters specified for an imager. You can set or modify these parameters as

required. You can later write the modified settings to the imager, or save them

to a dcf file.

Imaging

Imaging provides all the image-related functions that a 2D Imager can perform.

You can capture an image using the current settings, and the image will be dis-

played in an image window. Images captured from the imager can be saved to

files in different image formats. You can modify the image settings and save the

image settings to an INI file, which can be loaded later to capture new images.

Imaging also lets you preview the images continuously captured by the imager.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 187 188

Pas de commentaire

Honeywell 2020 Manuel d'utilisateur Page 135