Honeywell Stratos MS2x20 Series Guide de l'utilisateur télécharger pdf (Page 49)

³ 9 9 6 0 4 2

SCALE OPERATION

CALIBRATION

Bar Code Calibration Procedure without Remote Display*

4. Reinstall the platter onto the scanner/scale (see Figure 49).

Figure 48. Platter Installation

5. Enter bar code calibration mode. Use the vertical window to scan one of the following bar codes, whichever weight units (either

pounds or kilograms) the scanner/scale will be operating in. The scanner will beep once as it enters the bar code calibration mode

and the calibration utility will start.

Unit Calibration (Pounds)

For Kilogram weight units see instructions on page 44.

Figure 49. Entering Bar Code Calibration Mode (Pounds)

If a razz tone sounds, an error has occurred. Refer to Diagnostic Indicator Display; Error Codes starting on

page 31 for additional information.

* These procedures are for MS2320 StratosH Scanner/Diva Scale models only.

Pounds Calibration

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

Pas de commentaire

Honeywell Stratos MS2x20 Series Guide de l'utilisateur Page 49