Honeywell Stratos MS2x20 Series Guide de l'utilisateur télécharger pdf (Page 55)

SCALE OPERATION

SECURITY SEAL INSTALLATION

Wire Security Seal (Seal Conversion Kit

PN 46-00359)*

1. Temporarily remove the platter and place it in a safe location.

2. Install the calibration button sealing cover and through-hole sealing screw.

3. Tighten the screw and route the wire seal through the holes in the plate and screw.

Figure 59. Calibration Switch/Button Wire Security Seal Assembly

4. Leaving the least amount of slack in the wire loop as possible, close the wire seal and verify the seal connection is secure.

5. Reinstall the platter.

Figure 60. Platter Installation

* These procedures are for MS2320 StratosH Scanner/Diva Scale models only.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 71 72

Pas de commentaire

Honeywell Stratos MS2x20 Series Guide de l'utilisateur Page 55